what is rebuildable atomizer?
rebuildable atomizer:
First of all a buildable atomizer is actually an atomizer that vaper build himself.
Therefore, when you unpack the box, you can not use the atomizer.
In order to use it you must assemble it.
There are four different types of buildable atomizers.
Each type will give you different ways of refilling.
And also different taste and cloud vapor.
Types of rebuildable atomizer :
There are four main types of rebuildable atomizers.
The main types are RTA, RDTA , RDA and also RBA.
First : RBA stands for ReBuildable Atomizer.
It is also the main in every rebuildable atomizer.
Second : RDA stands for Rebuildable Dripping Atomizer.
This atomizer has a deck with posts to anchor the coils.
Third : RTA stands for Rebuildable Tank Atomizer.
That means that even though is an RBA you also have a tank.
Therefore you can not drip it, just refill your tank.
Fourth : RDTA stands for Rebuildable Dripping Tank Atomizer.
Finally the difference between the RTA and RDTA is:
even though it has a tank you can also drip it.
Suitable for:
First of all the buildable atomizers are for experience vapers.
That is because the patience that is needed in order to build a coil.
Also there are needed some very important tools.
Experienced Vapers world wide prefer buildable atomizers.
Because of the cloud chasing and also the flavor.
They believe that buildable atomizers give the best on both.
Also, some vapers treat this as a hobby.
Furthermore begginer vapers are not recommended to by or built a coil themselves.
Even though most mods have many protections, some of them lack the reading ohm one.
Therefore you have to be very careful with it.
What do you need in order to build a coil:
In order to build a coil you will need some tools.
First of all you are going to need wire which will be the coil.
Furthermore the tools are micro coil jig, organic cotton and also tweezers.
Most important is that you also need a meter.
Another tool that you are going to need is Cutting Pliers.
How to build a coil :
First you cut a piece of wire.
Then you wrap it on the micro coil jig.
After that you attach it to the atomizer.
Then, you screw the atomizer to the meter to verify the ohms.
Note: depending on the battery you have you need to know which lower and higher ohm are possible.
Finally you put the organic cotton into the coil.
Note: Please make sure you are fully informed before trying to build one yourself.
